Customizing The Show Vlans Output - HP 3500 Series Advanced Traffic Management Manual

Static Virtual LANs (VLANs)
Configuring VLANs
Field Display
id VLAN Id
name VLAN Name
status Status
voice Voice enabled
jumbo Jumbos enabled
ipconfig How the ip address was configured
ipaddr (IPv4) the IP address(es)
ipaddr (IPv6)
ipmask The subnet mask(s)
proxyarp Whether proxy arp is configured
localproxyarp Whether local proxy arp is configured
state "Up" if at least one port is up
1-34

Customizing the Show VLANs Output

The show vlans custom command allows you to customize the information
displayed when executing the show vlans command.
Syntax: show vlans custom [port <port-list>] column-list
Select the information that you want to display in the order
you want to display it for the show vlans command. You can
display information for one port or range of ports. If <port-
list> isn't specified, then all ports display.
Fields that can be included in the customized display are shown in the table
below.
The example in Figure 1-24 displays id at its default width, and will show up
to 20 characters of the VLAN name. The columns selected for display are
separated by spaces.
Example
5
Vlan55
Port-based
No
No
Manual
Disabled
DHCP/BootP
10.10.10.3
fe80::212:79ff:fe8d:8000
255.255.255.6
/64 (prefix for IPv6 is in format "/XX")
No
No
Up
Default
6
32
10
5
5
10
15 for IPv4
46 for IPv6
15
5
9
5