Simrad ES70 Operator's Manual page 21

a Click the
Setup
→ Setup menu on page 106
b Click
Installation
On the sub-menu, click
Installation
This dialog is used to control the communication between the ES70 computer
and the transceiver(s) and transducer(s).
c In the
Transceiver Installation
The ES70 will automatically search the network for transceivers.
Observe that all the frequency channels are listed in the dialog.
d
e Select a frequency channel that is available, and choose the correct transducer
in the spin box.
Note
This is a critical task. You must ensure that the correct transducer is selected.
If you connect the transceiver to a transducer that can not handle the power
rating, it may be damaged beyond repair.
f Observe that the status for the relevant frequency channels changes to Installed.
Click to save the current settings and close the dialog.
g
OK
4 Start normal operation.
This procedure explains how to set up the ES70 for normal operation.
a Observe the
ES70 presentation.
Click the
b
Operation
→ Operation menu on page 104
c Click the
Operation
343539/B
icon under the
Main
to open the
Installation
Transceiver Installation
dialog.
dialog, click
menu. It is normally located on the right hand side of the
Main
icon under the
button, and select Normal.
menu to open the
Setup
sub-menu.
to open the
.
Browse
menu to open the
Main
Installation
menu.
Transceiver
sub-menu.
Operation
19