Simrad ES70 Operator's Manual page 20

Simrad ES70
Windows XP
a Click
Start →Settings →Network Connections
b Click on the network adapter once to select it.
Right-click, and click
c
d On the list of connections, click
e Click
Use the following IP address
IP Address:
Subnet mask:
Click to save the settings.
f
OK
g Exit all dialogs.
Windows 7
Click
a
Start →Control Panel →Network Connections
b Click
Change adapter settings
c Click once on the network adapter to select it, and click
short-cut menu.
d On the list of connections, click
.
Properties
e Click
Use the following IP address
IP Address:
Subnet mask:
Click to save the settings.
f
OK
g Exit all dialogs.
2 On the computer, start the ES70 program.
3 Set up the transceiver(s) and transducer(s).
Each transceiver contains one or more frequency channels.
This phrase is used to identify the combination of a transceiver, transducers and the
frequencies offered. Split beam transceivers contain only one channel each.
The upper part of the
channels which either are, or have been, installed on the ES70. For each channel, a
label is provided.
Status
The following
Status
• : The frequency channel is already in use, probably by another echo sounder
Busy
on the same network. You can not connect to this channel.
• : This frequency channel is connected to you ES70 system.
Installed
• : This frequency channel can not be used.
Lost
• : This frequency channel is vacant and ready for use.
Available
This procedure explains how to install a frequency channel.
18
on the short-cut menu.
Properties
Internet Protocol (TCP/IP)
, and enter the IP address and network mask.
157.237.14.12
255.255.0.0
on the left menu.
Internet Protocol 4 (TCP/IPv4)
, and enter the IP address and network mask.
157.237.14.12
255.255.0.0
Transceiver Installation
values are available:
.
, and then
.
Properties
dialog displays a list of frequency
.
Properties
on the
, and then
343539/B