Air Filter & Pre-Cleaner Service (V-Twin Models) - Snapper ELT19540RD Operator's Manual

Air Filter & Pre-Cleaner Service
V-TWIN MODELS
Service Interval: Pre-Cleaner: Every 25 hours or as
required. Air Filter: Every 50 hours or as required.
Replacement Interval: Pre-Cleaner: As required. Air
Filter: Every 200 hours or once per season.
Air Filter Removal & Installation
1. Unscrew the four knobs (A, Figure 30) by turning
counterclockwise.
2. Remove the cover (B). Remove the air filter (C) and
pre-cleaner (D).
3. Install the pre-cleaner (D) with the mesh side up.
Install the air filter (C) as shown.
4. Install the cover (B) making sure the tabs are inserted
into their slots. Secure by turning screws clockwise
until snug.
Pre-Cleaner Service
NOTE: Replace a worn or damaged pre-cleaner.
1. Wash the pre-cleaner in liquid detergent and water
(see Figure 31).
2. Squeeze the pre-cleaner dry and saturate with
engine oil. Remove all excess oil by squeezing the
pre-cleaner in an absorbent cloth.
Air Filter Service
NOTE: Replace a worn or damaged air filter.
1. If stamped "Washable," the filter can be washed with
warm water and mild soap (see Figure 31).
2. Rinse with tap water with the screen side UP allowing
dirt and debris to filter out.
3. Allow the filter to dry overnight before reinstalling
A
Figure 30. Air Filter Assembly - V-Twin Models
A. Knobs
B. Cover
C. Air Filter
D. Pre-Cleaner
Pre-Cleaner
1.
2.
Figure 31. Air Filter Service
27
Regular Maintenance
B
C
D
Air Filter
1.
2.