Air Filter & Pre-Cleaner Service (Single Cylinder Models) - Snapper ELT19540RD Operator's Manual

Regular Maintenance
Air Filter & Pre-Cleaner Service
SINGLE CYLINDER MODELS - BRIGGS & STRATTON
Service Interval: Pre-Cleaner: Every 25 hours or as
required. Air Filter: Every 50 hours or as required.
Replacement Interval: Pre-Cleaner: As required. Air
Filter: Every 200 hours or once per season.
Air Filter Removal & Installation
1. Lift up on the latch (A, Figure 32).
2. Rotate the latch to the inside.
3. Pull cover (B) out and off.
4. Lift air filter (C, Figure 33) and pre-cleaner (D) if
equipped, from blower housing.
5. Install the pre-cleaner (D) with the mesh side up.
Install the air filter (C) as shown.
6. Install the cover (B) making sure the tabs are inserted
into their slots. Secure with the latch (A).
Pre-Cleaner Service
NOTE: Replace a worn or damaged pre-cleaner.
1. Wash the pre-cleaner in liquid detergent and water
(see Figure 31).
2. Squeeze the pre-cleaner dry. Do not oil pre-
cleaner.
Air Filter Service
NOTE: Replace a worn or damaged air filter.
1. If stamped "Washable," the filter can be washed with
warm water and mild soap (see Figure 31).
2. Rinse with tap water with the screen side up allowing
dirt and debris to filter out.
3. Allow the filter to dry overnight before reinstalling.
1.
Figure 32. Air Filter Assembly - Single Cylinder Models
A. Latch
B. Cover
Figure 33. Air Filter Service - Single Cylinder Models
A. Latch
B. Cover
C. Air Filter
D. Pre-Cleaner
28
A
B
A
B
3.
A
A
B
2.
C
D
B