Air Filter & Pre-Cleaner Service (Briggs & Stratton Two Cylinder Models) - Snapper ELT18540 Operator's Manual

Regular Maintenance
Air Filter & Pre-Cleaner Service
BRIGGS & STRATTON TWO CYLINDER MODELS
Air Filter Removal & Installation
1. Unscrew the four knobs (A, Figure 11) by turning
counter clockwise.
2. Remove the cover (B). Remove the filter (C) and pre-
cleaner (D).
3. Install the pre-cleaner (D) with the mesh side up.
Install the filter (C) as shown.
4. Install the cover (B) making sure the tabs are inserted
into their slots. Secure by turning screws clockwise
until snug.
Pre-Cleaner Service
NOTE: Replace a worn or damaged pre-cleaner.
1. Figure 12. Wash the pre-cleaner in liquid detergent
and water.
2. Squeeze the pre-cleaner dry and saturate with engine
oil. Remove all excess oil by squeezing the pre-
cleaner in an absorbent cloth.
Air Filter Service
NOTE: Replace a worn or damaged air filter.
1. Figure 12. If stamped "Washable," the filter can be
washed with warm water and mild soap.
2. Rinse with tap water with the screen side UP allowing
dirt and debris to filter out.
3. Allow the filter to dry overnight before reinstalling.
A
Figure 11. Air Filter Assembly - Briggs & Stratton
Twin Cylinder Models
A. Knobs
B. Air Filter Cover
C. Air Filter
D. Pre-Cleaner
Figure 12. Air Filter Service
20
B
C
D