Mower Cutting Height; Attaching A Trailer; Storage - Snapper ELT19540RD Operator's Manual

A
Figure 9. Raising & Lowering Mower
A. Mower Lift Lever
Cutting Height Adjustment
The mower lift lever (A, Figure 9) is used to lower the
deck to cutting position and raise the deck to transport
position.
To lower the deck, pull back slightly on the mower lift
lever (A), push it to the left and slide it down. To raise
the deck to transport pull up on the mower lift lever (A)
and lock in notch to the right. Do not cut in transport.

Attaching a Trailer

The maximum horizontal drawbar force allowed is 280
Newton. The maximum vertical drawbar force is 160
Newton. This equates to a 250 lbs (113 kg) trailer on a
10 degree hill. Secure the trailer with an appropriately
sized clevis pin (A, Figure 10) and clip (B).
A
B
Figure 10. Trailer Weight Recommendations
A. Clevis Pin B. Clip
WARNING
Never store the unit (with fuel) in an enclosed,
poorly ventilated structure. Fuel vapors can
travel to an ignition source (such as a furnace,
water heater, etc.) and cause an explosion.
Fuel vapor is also toxic to humans and animals.

Storage

Before you store your unit for the off-season, read the
Maintenance and Storage instructions in the Safety
Rules section, then perform the following steps:
• Disengage the PTO, set the parking brake, and
remove the key.
• Perform engine maintenance and storage measures
listed in the engine owner's manual. This includes
draining the fuel system, or adding stabilizer to the
fuel (do not store a fueled unit in an enclosed
structure - see warning).
• Battery life will be increased if it is removed, put in a
cool, dry place and fully charged about once a month.
If the battery is left in the unit, disconnect the
negative cable.
Before starting the unit after it has been stored:
• Check all fluid levels. Check all maintenance items.
• Perform all recommended checks and procedures
found in the engine owner's manual.
• Allow the engine to warm up for several minutes
before use.
17
Operating the Tractor