Specifications - Snapper ELT19540RD Operator's Manual

NOTE: Specifications are correct at time of printing and are subject to change without notice.
ENGINE:
22 HP* Briggs & Stratton
Make Briggs & Stratton
Model Intek
Horsepower 22 @ 2700 +/- 100 rpm
Displacement 44.2 Cu. in (724 cc)
Electrical System 12 Volt, 9 amp. Alternator, Battery: 230 CCA
Oil Capacity 64 Oz. (1.9 L)
19.5 HP* Briggs & Stratton
Make Briggs & Stratton
Model Intek
Horsepower 19.5 @ 2700 +/- 100 rpm
Displacement 30.5 Cu. in (500 cc)
Electrical System 12 Volt, 9 amp. Alternator, Battery: 230 CCA
Oil Capacity 48 Oz. (1.4 L)
CHASSIS:
Fuel Tank Cap. Capacity: 2.5 Gallons (9,4 L)
Rear Wheels Tire Size: 22 x 10 -8
Inflation Pressure: 10 psi (,68 bar)
Front Wheels Tire Size: 15 x 6.0-6
Inflation Press.: 12-14 psi (,82-0,96 bar)
*Briggs & Stratton Models: The gross power rating for individual gas engine models is labeled in accordance with
SAE (Society of Automotive Engineers) code J1940 (Small Engine Power & Torque Rating Procedure), and rating
performance has been obtained and corrected in accordance with SAE J1995 (Revision 2002-05). Torque values are
derived at 3060 RPM; horsepower values are derived at 3600 RPM. Actual gross engine power will be lower and is
affected by, among other things, ambient operating conditions and engine-to-engine variability. Given both the wide
array of products on which engines are placed and the variety of environmental issues applicable to operating the
equipment, the gas engine will not develop the rated gross power when used in a given piece of power equipment
(actual "on-site" or net horsepower). This difference is due to a variety of factors including, but not limited to,
accessories (air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application limitations, ambient
operating conditions (temperature, humidity, altitude), and engine-to-engine variability. Due to manufacturing and
capacity limitations, Briggs & Stratton may substitute an engine of higher rated power for this Series engine.
TRANSMISSION:
K46
Type Hydrostatic Tuff Torq K46
Hydraulic Fluid 10w 30 Premium Engine Oil
Speeds Forward: 0-5.5 MPH (9.0 km/h)
@ 3400 rpm Reverse: 0-3.0 MPH (4.6 km/h)
Continuous Torque 170 ft-lbs.
Output
Drawbar Rating 227 lbs (103 kg)
Maximum Weight 675 lbs (306 kg)
on Axle
DIMENSIONS:
Overall Length 103"
Overall Width 42"
Height 49"
Weight: 617 lbs (280 kg)
19.5 hp or 22 hp Tractor
w/ 40" Mower Deck
37

Specifications