Nortel DMS-100 Series General Description Manual page 107

Procedure 3-2 Single LCM ringing generator configuration change procedure
At the MAP terminal
1 To access table LCMINV, type
> TABLE LCMINV
and press the Enter key.
2 To position on the tuple for the LCM, type
> POS RLCM 0 0
and press the Enter key.
Example of a MAP display
>POS RLCM 0 0
RLCM 00 0 RLCM
N 3 256K 256K
LCM Y
For more information about ringing types, refer to the Customer Data Schema
Reference Manual and chapter "DMS-100 ringing overview" in this document.
3 Check the RNGTYPE for the LCM. The previous example shows a
RNGTYPE of frequency selective.
4 To quit the table, type
> QUIT ALL
and press the Enter key.
5 To access the PM level of the MAP terminal, type
> MAPCI;MTC;PM
and press the Enter key.
Example of a MAP display:
PM
6 To post the LCM, type
> POST LCM RLCM 0 0
and press the Enter key.
Example of a MAP display
4 1 P 29 6X04AA XLCM11BD
F REA 20 30 40 50 HLCM
RNGTYPE is set to frequency selective (F).
SysB ManB
0 0
Ringing in Series II peripherals 3-39
(16)(18)(17)(19)$
OffL CBsy
0 0
DMS-100 Ringing System
LTC 0
IsTb InSv
0 39