Advertisement
Available languages
Available languages
The default gateway address is the IP address of your wireless router. Check your wireless
router to verify this address. This will ensure that you can connect to the wireless network.
If you cannot complete this ping, make sure your wireless settings are correct and that the
802.11g 54Mbps USB Adapter is fully inserted into a USB port on your computer.
3 Type Ping followed by the outside Internet address that is provided by your ISP. This proce-
dure will ensure that your wireless network can connect to the Internet. If you cannot com-
plete this ping, verify your internet connection between your modem and your wireless
router or access point.
4Type Ping followed by your known DNS server address. This will allow you to resolve valid
Internet host names to IP addresses and to verify that you can access the Internet.
If you cannot complete any of these pings, uninstall the 802.11g 54Mbps USB Adapter and
repeat the installation procedure.
Security is enabled on my Wireless Router and my 802.11g 54Mbps USB Adapter can-
not connect.
Possible Solution:
The 802.11g 54Mbps USB Adapter supports 64 and 128 bit encryption. Verify that all of the security
features you have entered for the profile of your 802.11g 54Mbps USB Adapter match the settings
for your Wireless Router. For more information about setting up connection profiles and security
features, refer to the Navigating the Wireless Configuration Utility section of the User Guide on the
U.S. Robotics Installation CD-ROM.
Possible Solution:
If you created a Profile Setting, unplug the 802.11g 54Mbps USB Adapter and then plug it back in.
The U.S. Robotics Installation CD-ROM did not automatically launch when I inserted
the Installation CD-ROM.
Possible Solution:
Some programs may keep the autolaunch feature of the Installation CD-ROM from beginning. Close
any open applications and reinsert the Installation CD-ROM. If your CD-ROM still does not automat-
ically launch, click Windows Start, Run, and type D:\setup (if your CD-ROM drive uses a different
letter, type that letter in place of "D") and click OK.
I accidentally clicked Cancel during the installation procedure.
Possible Solution:
Remove and reinsert the U.S. Robotics Installation CD-ROM into your CD-ROM drive. Repeat the
8
Advertisement
