Chicago Electric 66523 Set Up, Operating, And Servicing Instructions page 8

subheadings therein before set
up or use of this product.
SERIOuS INjuRY:
Operate only with proper spark
arrestor installed. Operation of
this equipment may create
sparks that can start fires
around dry vegetation.
The operator should contact
local fire agencies for laws or
regulations relating to fire
prevention requirements.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Starting the Engine
Inspect the Generator looking
for damaged, loose, and
missing parts before set up and
starting. If any problems are
found, do not use the machine
until properly repaired.
Checking and Filling Engine Oil:
CAuTION! Your Warranty is VOID if the
Engine's Crankcase is not properly
filled with oil before each use. Before
each use, check the oil level. Do not
run the Engine with low or no engine
oil. Running the Engine with no or
low engine oil WILL permanently
damage the Engine.
1. Remove the Engine's Dipstick and
wipe it off with a clean rag.
(See Figure A.)
SKU 66523 For technical questions, please call 1-800-444-3353.
TO PREvENT
2. Reinsert the Dipstick completely
(but do not screw it in) and remove
it to check the oil level. The oil level
should be between the HIGH and
LOW marks on the Dipstick.
(See Figure A.) Note: Inspect the
O-Ring at the neck of the Dipstick. If
cracked, torn or damaged it must be
replaced.
3. If the oil level is below the low mark
add the appropriate type of oil until
the oil level is between the high and
the low marks.
Oil type and capacity:
SAE 10W-30 / 13.5 Ounces
4. Replace the Oil Dipstick.
(See Figure A.)
CAuTION! Do not run the Engine with too
little or too much oil. The Engine will
be permanently damaged.
FIGuRE A
Checking and Filling Fuel:
1. Allow engine to cool down prior to re-
fueling. Remove the Fuel Cap (14)
and check the fuel level.
(See Figure B, next page.)
OIL
dIPSTICK
Page 8