ActionTec GT701-WG User Manual page 63

Actiontec 54 Mbps Wireless DSL Gateway User Manual
Obtain an IP Address through PPPoE or PPPoA
Select one of these options to allow the Gateway to use the Point-to-Point over
Ethernet ( ) or Point-to-Point over
PPPoE
If a User Name, Password and/or Static
should be displayed in the "Broadband Connection via
If not, enter the information now. If the information is unavailable, contact the
Internet Service Provider (
PPP Auto Connect
auto connect is activated (by clicking in the appropriate check box), the
If
PPP
Gateway will attempt to automatically redial the
or disconnected during an online session.
Obtain an IP Through DHCP
Select this option if the
(used for configurations without a Static
Gateway will query the Internet Service Provider (
and routing information, which will terminate at the Gateway, as opposed to the
address and routing information being bridged to terminate at the computer. This
allows the use of the router capabilities for the Local Area Network (
Some s need to authenticate their end users with a Host Name and/or Domain
ISP
Name. If this is the case, check with the
enter them in the "Broadband Connection via
require these settings, leave the text boxes blank.
ATM
.
ISP)
service is configured to use
IP
IP
ISP
60
( ) protocol.
PPPoA
was entered during Basic Setup, it
IP
PPPoE/PPPoA
connection if it is dropped
PPP
RFC 1483
assigned by an
ISP
) to receive the
ISP
for a host name and domain name and
" screen. If the
DHCP
" screen.
Bridged or Routed
). In this mode, the
address
IP
).
LAN
does not
ISP
IP