Edimax EW-7301APg User Manual page 16

3.2.1.2. AP Mode
Step 1: IP Segment Set-up for Administrator's PC
Set the IP segment of the administrator's computer to be in the same range as EW-7301APg/EW-
7302APg for accessing the system. Do not duplicate the IP address used here with IP address of
EW-7301APg/EW-7302APg or any other device within the network.
Example of IP Segment:
The value for underlined area can be changed as desired; the valid range is 1 ~ 254. However, 1
shall be avoided as it is already used by EW-7301APg/EW-7302APg; use 100 as an example here.
•
IP Address: 192.168.1.100
•
Subnet Mask: 255.255.255.0.
Note:
1. For more information on default IP addresses, please refer to Section 3.2.1-Instruction to Web
Management Interface.
2. For more information on setting IP address of the administrator's computer, pleas refer to
Appendix C-Windows TCP/ IP Setting.
Step 2: Launch Web Browser
Launch a web browser to access the web management interface of AP mode by entering the
default IP address, http://192.168.1.1, in the URL field, and then press Enter.
Note: The default IP addresses for CPE mode and AP mode are different. Using an incorrect
default IP address will result in no Login Page shown in web browser. Please make sure correct IP
address is used for the desired mode; refer to Section 3.2.1-Instruction to Web Management
Interface for detailed default IP addresses.
15
EW-7301APg/EW-7302APg
User Manual