Mounting - Siemens SINAMICS S 1PH7 Configuration Manual

Information for using the motors

7.5 Mounting

7.5 Mounting
7.5
These motors are electrically operated. When electrical equipment is operated, certain
parts of these motors are at hazardous voltage levels. If this motor is not correctly
handled/operated, this can result in death or severe bodily injury as well as significant
material damage. Please carefully observe the warning information in this section an on the
product itself.
Only qualified personnel may carry-out service or repair work on this motor.
Before starting any work, the motor must be disconnected from the line supply and
grounded.
Only spare parts, certified by the manufacturer, may be used.
The specified service/maintenance intervals and measures as well as the procedures for
repair and replacement must be carefully maintained and observed.
When transporting the motors, use all of the hoisting lugs provided!
A suitable crane/lifting device must be used. Incorrect execution, unsuitable or damaged
equipment and resources can result in injury and material damage. The hoisting and
transport equipment as well as the load suspension equipment must be in full compliance
with the appropriate regulations.
All work should be undertaken with the system in a no-voltage condition!
Other information and instructions in the Operating Instructions must be carefully observed.
The motor should be connected up according to the circuit diagram provided.
In the terminal box it must be ensure that the connecting cables are insulated with respect
to the terminal board cover.
After the motor has been installed, the brake (if one is used) must be checked to ensure
that it is functioning perfectly!
226
WARNING
WARNING
1PH7 induction motors (Machine tools)
Configuration Manual, (APH7W), 04/2009, 6SN1197-0AD72-0BP0