Assembly - Snapper SP110 Operator's Manual

Safety instructions for
maintenance
WARNING: Read the warning
instructions that follow before you use
the product.
• The exhaust fumes from the engine contain
carbon monoxide, an odorless, poisonous and
very dangerous gas. Do not start the engine
indoors or in closed spaces.
• Before you do the maintenance on the product,
stop the engine and remove the ignition cable
from the spark plug.
• Use protective gloves when you do maintenance
on the cutting equipment. The blade is very
sharp and cuts can easily occur.
Introduction
WARNING: Read and understand the
safety chapter before you assemble the
product.
To remove the product from the
carton
1. Remove loose parts included with the product.
2. Cut down the two end corners of the carton and
put the end panel down flat.
3. Remove all package materials.
4. Remove the product from the carton and make
sure no loose parts are left in the carton.
To assemble the handle
1. Lift the lower part of the handlebar to operation
position.
2. Align the screw holes at the bottom of the handle
with the screw holes in the handle assembly.
3. Attach the supplied bolts.
4. Put the upper handle in position on top of the
lower handle. Tighten the 2 knobs.
To install the starter rope handle
1. Attach the loop for the starter rope and the T-
knob. Do not tighten fully.
2. Hold the engine brake handle against the
handlebar.
912 - 001 -
• Accessories and changes to the product that are
not approved by the manufacturer, can cause
serious injury or death. Do not change the
product. Always use accessories that are
approved by the manufacturer.
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Only do the maintenance as given in this
operator's manual. All other servicing must be
done by an approved service agent.
• Let an approved service agent do servicing on
the product regularly.
• Replace damaged, worn or broken parts.

Assembly

3. Slowly pull out the starter rope and put it into the
loop for the starter rope.
4. Tighten the T-knob.
To assemble the grass catcher
1. Attach the grass catcher frame to the grass bag.
Make sure that the rigid part of the bag is on the
bottom. Keep the handle of the frame out of the
top of the bag.
2. Use the clips to attach the grass bag to the
frame.
7