Snapper SP110 Operator's Manual page 9

The adjuster lever is spring loaded.
1. Squeeze the height adjuster lever in the direction
of the wheel.
2. Move the wheel up or down for your cutting
requirements.
To use the product with the grass
catcher
1. Lift the rear door and put the grass catcher on
the bracket.
2. Release the rear door and put it on top of the
grass bag frame.
3. Remove the side discharge deflector, if it is
attached.
4. Make sure that the side discharge guard is tightly
closed against the product
To change the product to side
discharge mode
1. Lift the rear door and remove the grass bag, if it
is installed.
2. Let the rear door close. Make sure that the rear
door is tightly closed against the product.
3. Open the side discharge guard and install the
side discharge deflector.
912 - 001 -
4. Let the side discharge guard close against the
deflector. Make sure that the deflector is tightly in
position before you operate the product.
To use the product without grass
catcher and side discharge
1. Lift the rear door and remove the grass catcher.
2. Make sure that the rear door is tightly closed
against the product.
3. Remove the side discharge deflector, if it is
installed, and let the side discharge guard close.
4. Make sure that the side discharge guard is tightly
closed against the product.
To start the product
1. Stay behind the product.
2. Hold the engine brake handle against the
handlebar.
9