Transportation And Storage - Snapper SP110 Operator's Manual

causes the product to stop, replace the damaged
blade. Let the service center estimate if the blade
can be sharpened or must be replaced.
To replace the blade
1. Lock the blade with a block of wood.
2. Remove the blade bolt.
3. Remove the blade.
4. Examine the blade support and blade bolt to see
if there are damages.
5. Examine the motor shaft to make sure that it is
not bent.
6. When you attach the new blade, point the angled
ends of the blade in the direction of the cutting
cover.

Transportation and storage

• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from
electrical devices or boilers, can start a fire.
• Always use approved containers for storage and
transportation of fuel.
• Empty the fuel tank before you put the product in
storage for a long period of time. Discard the fuel
at an applicable disposal location
912 - 001 -
Transportation and storage
7. Make sure that the blade is aligned with the
center of the motor shaft.
8. Lock the blade with a block of wood. Attach the
spring washer and tighten the bolt and washer
with a torque of 47-54 Nm.
9. Pull the blade around by hand and make sure
that it turns freely.
WARNING: Use heavy duty gloves.
The blade is very sharp and cuts can
easily occur.
10. Start the product to do a test of the blade. If the
blade is not correctly attached, there is vibration
in the product or the cutting result is
unsatisfactory.
• Safely attach the product during transportation to
prevent damage and accidents.
• Keep the product in a locked area to prevent
access for children or persons that are not
approved.
• Keep the product in a dry and frost free area.
13