Table of Contents
Advertisement
Mode setting
Operation
Press
key.
Press ENTER key.
Press
key or
Press ENTER key.
Follow the same operation
procedure as error 1.
Switching in the order of
errors 2, 3, 4 and 5
Press
key.
Press ENTER key.
(for 3 seconds)
Press
key.
Press and hold ENTER key
u n t i l t h e d i s p l a y e d c o d e
blinks (for 3 seconds).
SL-VGU1-C setting default values (values set in our factory before delivery)
Setting of transmission mode
Setting of display to decimal /
hexadecimal number display
Buffer memory assignment
Presetting
Description / Function
Displays the error 1 output operation.
Blinks the displayed error 1 output operation.
Selects the external output type for the detected error
from the following two types:
key.
: Outputs the error signal from error output 1 of the controller.
: Will not output any error signal.
Determines the error 1 output operation.
Same as error 1
Displays the code of the default setting.
Displays the indicator check pattern, and sets the default
values.
Sequentially displays all the setting items of the CONFIG
mode, and sets these items to the initial values (default
values).
Clears the addresses of all the units specified in the sys-
tem setting.
Displays the baud rate and the station numbers of the
CC-Link side.
Displays the code of the system setting.
Enters the system setting (blinks).
Blinks the number of connected nodes (I/O units).
Setting of number of
I/O control points
Displaying number of
stations
I/O setting 0
I/O setting 1
I/O setting 2
I/O setting 3
Starting
Indication
Example
Error output 1
No error output
Example
Same as error 1
End
Example
If 4 I/O units are
connected:
End
Output hold / clear
Setting of error 1
output operation
Setting of error 2
output operation
Setting of error 3
output operation
Setting of error 4
output operation
Setting of error 5
output operation
53
Advertisement
Table of Contents
