Husqvarna 115H Operator's Manual page 36

Message Cause
No drive
The product has got caught in some-
thing.
The work area includes a steep slope.
The guide wire is not laid at an angle
on a slope.
Wheel motor over- The product has got caught in some-
loaded, right
thing.
Wheel motor over-
loaded, left
Charging station
The contact between the charging
blocked
strips and contact strips may be poor
and the product has made a number of
attempts to charge.
An object is obstructing the product.
The charging station is tilted or bent.
Stuck in charging
There is an object in the way of the
station
product preventing it from leaving the
charging station.
Upside down
The product is leaning too much or has
turned over.
Needs manual
The product is set to the
charging area operating mode.
Next start hh:mm
The schedule setting prevents the
product from operating.
The rest period is in progress. The
product has an inbuilt standby period
according to the Standby time table.
The clock on the product is not correct.
36 - Troubleshooting
Action
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
Steep slopes should be isolated. Refer
To examine where to put the guide
to
wire on page 17 .
If the guide wire is laid on a slope, it
must be laid at an angle across the
slope. Refer to
put the guide wire on page 17 .
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
Put the product in the charging station
and check that the charging strips and
contact strips make good contact.
Remove the object.
Confirm that the charging station is
placed on a fully flat and horizontal
ground. The charging station must not
be tilted or bent.
Remove the object.
Turn the product the right way up.
Secondary
Place the product in the charging sta-
tion. This behavior is normal and no ac-
tion is required.
Change the schedule settings. Refer to
To do the schedule settings on page
20 .
This behavior is normal and no action
is required.
Set the time. Refer to
date on page 24 .
To examine where to
To set the time &
982 - 001 - 12.12.2018