Table of Contents
Advertisement
•
If you have a paving stone path that is in
level with the lawn, put the boundary wire
below the paving stone.
Note: If the paving stone is minimum 30
cm / 12 in. wide, use the factory setting for
the Drive Past Wire function to cut all the
grass adjacent to the paving stone.
CAUTION: Do not let the product
operate on gravel.
•
If you make an island, put the boundary wire
that runs to and from the island near
together (E). Put the wires in the same
stake.
•
Make an eyelet (F) where the guide wire is
to be connected to the boundary wire.
CAUTION: Do not make sharp
bends when you install the
boundary wire.
CAUTION: For careful operation
without noise, isolate all obstacles
such as trees, roots and stones.
3.3.3.1 To put the boundary wire in a slope
•
For slopes steeper than 30% inside the work
area, isolate the slope with boundary wire.
•
For slopes steeper than 15% along the outer
edge of the lawn, put the boundary wire 20
cm / 8 in. (A) from the edge.
•
For slopes adjacent to a public road, put a
fence or a protective wall along the outer
edge of the slope.
>15%
A
3.3.3.2 Passages
A passage is a section that has boundary wire on
each side and that connects 2 work areas. The
16 - Installation
passage must be a minimum of 60 cm / 24 in.
wide.
Note: If a passage is less than 2 m / 6.5 ft. wide,
install a guide wire through the passage.
3.3.3.3 To make an island
•
Put the boundary wire to and around the
obstacle to make an island.
•
Put the 2 sections of boundary wire that run
to and from the obstacle together.
•
Put the 2 sections of boundary wire in the
same stake.
0-30%
0 cm / 0"
CAUTION: Do not put a section of
boundary wire across the other.
The sections of boundary wire
must be parallel.
CAUTION: Do not put the guide
wire across the boundary wire, for
example a boundary wire that
goes to an island.
982 - 001 - 12.12.2018
Hide quick links:
Advertisement
Table of Contents
