Husqvarna 115H Operator's Manual page 17

3.3.3.4 To make a secondary area
Make a secondary area if the work area has 2
areas that are not connected with a passage.
• Put the boundary wire around the secondary
area (B) to make an island. The work area
with the charging station is the main area
(A). Refer to To make an island on page 16 .
B
A
Note: When the product cuts grass in the
secondary area, the
must be selected. Refer to
27 .
3.3.4 To examine where to put the guide
wire
• Put the guide wire in a line at a minimum of
1 m / 3.3 ft. in front of the charging station.
G
• Make sure that the guide wire has as much
free area as possible to the left of the guide
wire when facing the charging station. Refer
Guide calibration on page 20 .
to
• Put the guide wire minimum 30 cm / 12 in.
from the boundary wire.
982 - 001 - 12.12.2018
Secondary area mode
2nd area on page
Min 1m / 3.3ft
• Do not make sharp bends when you install
the guide wire.
• If the work area has a slope, put the guide
wire diagonally across the slope.
3.3.5 Work area examples
D
B
• If the charging station is put in a small area
(A), make sure that the distance to the
boundary wire is at a minimum 2 m / 6.6 ft.
• If the work area has a passage (B), make
sure that the distance to the boundary wire
is at a minimum 2 m / 6.5 ft. If the passage is
smaller than 2 m / 6.5 ft., install a guide wire
through the passage. Minimum passage
between the boundary wire is 60 cm / 24 in.
• If the work area has areas which are
connected by small passages (C), you can
change the settings in
To set the Lawn Coverage function
Refer to
on page 22 .
• If the work area includes a secondary area
To make a secondary area on
(D), refer to
page 17 . Put the product in the secondary
Secondary area mode .
area and select
A
C
Lawn Coverage .
Installation - 17