Husqvarna 115H Operator's Manual page 35

Message Cause
Trapped
The product has got caught in some-
thing.
The product is stuck behind a number
of obstacles.
Outside working
The boundary wire connections to the
area charging station are crossed.
The boundary wire is too close to the
edge of the work area.
The work area slopes too much by the
boundary loop.
The boundary wire is laid in the wrong
direction around an island.
Disturbances from metal objects (fen-
ces, reinforcement steel) or buried ca-
bles close by.
The product finds it hard to distinguish
the signal from another product installa-
tion close by.
Empty battery
The product cannot find the charging
station.
The guide wire is broken or not connec-
ted.
The battery is spent.
The charging station's antenna is de-
fective.
Wrong PIN code
Wrong PIN code has been entered.
Five attempts are permitted, and the
keypad is then blocked for five minutes.
982 - 001 - 12.12.2018
Action
Free the product and rectify the reason
for it becoming trapped.
Check if there are any obstacles which
make it hard for the product to move on
from this location.
Check that the boundary wire is con-
nected correctly.
Check that the boundary wire has been
laid according to the instructions. Refer
To install the boundary wire on page
to
18 .
Try moving the boundary wire.
Place the product in the charging sta-
tion and generate a new loop signal.
Check that the charging station and the
guide wire are installed in accordance
with the instructions. Refer to
the guide wire on page 18 .
Find out where the break is and rectify
it.
Replace the battery. Refer to
on page 31 .
Check if the indicator lamp in the
charging station flashes red. Refer to
Indicator lamp in the charging station
on page 39 .
Enter the correct PIN code. Contact
Husqvarna customer service if you for-
get the PIN code.
Troubleshooting - 35
To install
Battery