MSI MS-98E3 Manual page 41

▶
Console Redirection Settings
▶
Terminal Type
To operate the system's console redirection, you need a terminal
supporting ANSI terminal protocol and a RS-232 null modem cable
connected between the host system and terminal(s). This setting
specifies the type of terminal device for console redirection.
▶
Bits per second, Data Bits, Parity, Stop Bits
This setting specifies the transfer rate (bits per second, data bits,
parity, stop bits) of Console Redirection.
▶
Flow Control
Flow control is the process of managing the rate of data transmis-
sion between two nodes. It's the process of adjusting the flow of
data from one device to another to ensure that the receiving device
can handle all of the incoming data. This is particularly important
where the sending device is capable of sending data much faster
than the receiving device can receive it.
▶
VT-UTF8 Combo Key Support
This setting enables/disables the VT-UTF8 combination key support
for ANSI/VT100 terminals.
▶
Recorder Mode, Resolution 100x31
These settings enable/disable the recorder mode and the resolu-
tion 100x31.
▶
Legacy OS Redirection Resolution
This setting specifies the redirection resolution of legacy OS.
▶
Putty Keypad
PuTTY is a terminal emulator for Windows. This setting controls the
numeric keypad for use in PuTTY.
MS-98E3
3-13