Assembly - Grizzly G0803Z Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
LACERATION
Bandsaw blades and some
sheet
sharp. Wear heavy leather
gloves while handling to
reduce risk of being cut.
To assemble bandsaw:
1. Attach (4) rubber feet to bandsaw base (see
Figure 11). Rubber feet simply press onto
corners of base.
Bandsaw
Base
Figure 11. Rubber feet attached to base.
Model G0803Z (Mfd. Since 12/18)
HAZARD!
metal parts are
Rubber Foot
(1 of 4)
2. Loosen scale indicator and position it down
(see Figure 12), then remove table tilt lock
lever, flat washer, table tilt adjustment knob,
and shoulder bolt with spring (see Figure 12).
Adjustment
Knob
Figure 12. Location of table controls that must
be removed or adjusted.
3.
Turn guide post adjustment knob (see
Figure 3 on Page 4 for location) counter-
clockwise to raise guide post all the way up.
4. Remove wing bolt, lock washer, flat washer,
and D-nut from table assembly. Make note of
how fasteners secure to fence assembly for
re-installation later.
5. Using gap in table (see Figure 13), slide
table assembly through blade and rotate
assembly 90°. Position assembly as shown
in Figure 13.
Gap
Figure 13. Table assembly positioned on saw.
6. Re-install components removed in Step 2.
DO NOT fully tighten yet.
Lock
Lever
Indicator
Positioned
Down
Table/Trunnion
Assembly
-15-