Table of Contents
Advertisement
Charge the
battery!
Your terminal was
not shut down
properly the last
time it was used.
Unsaved data
was lost.
[SF+2]
No execution
program selected.
Contact your
administrator.
Low battery indication—Level 2
Problem
When the power is turned on or during execution of
program (System Mode or application), the battery
output level has lowered.
If lower battery is detected, the BHT beeps five
times (for 0.1 second per beep) and then turns
itself off. Depending upon the battery level, the
beeper may not sound five times.
Solution
Replace it with a fully charged battery cartridge or
charge it.
Abnormally powered off last
Problem
After powered off abnormally*, the BHT had been
left with no battery cartridge loaded or with a dis-
charged battery cartridge loaded, so unsaved data
was lost.
(*"Normally powered off" refers to powered off
with the PW key or by the auto power-off feature.)
Solution
Contact your system administrator.
Execution program not selected
Problem
No user program has been selected as an execution
program to be run when the power is turned on.
If this error occurs, the BHT beeps five times
(for 0.1 second per beep) and then turns itself
off.
Solution
Contact your system administrator.
Advertisement
Table of Contents
