Adjusting For Bottled Gas; 5.3 Adjusting For Town Gas - Smeg GKL64-3 Instructions For Use Manual

Instructions for the Installer
5.2

Adjusting for bottled gas

Undo the screw A and push the support B fully down. Remove the nozzle C with a
spanner and fit the suitable one following the instructions in the tables referring to the
type of gas to be used. The nozzle must not be tightened with a torque of more than 3
Nm. Return the support B to its original position, so that the nozzle C is perfectly
covered.
Regulate the air flow by moving the Venturi pipe D until the distance "X" stated in point
"5.5 Adjusting the primary air flow" is obtained and secure it with the screw A. When the
adjustments are complete, restore the seals with wax or an equivalent material.
Burner
Auxiliary
Semi rapid
Rapid (3)
Rapid (7)
Rapid (6)
Ultra-Rapid
Double
Internal
Crown (4)
External
Double
Internal
Crown (8)
External

5.3 Adjusting for town gas

To allow the unit to work with this type of gas, perform the same operations described in
paragraph "5.2 Adjusting for bottle gas", but choose the nozzles and regulate the primary air for
town gas, as shown in the following table and in paragraph "
Burner
Auxiliary
Semi rapid
Rapid (3)
Rapid (7)
Rapid (6)
Ultra-Rapid
Double Internal
Crown (4)
External
Double Internal
Crown (8)
External
Nominal
heat Bottled gas – G30/G31 30/37 mbar
capacity
(kW)
Nozzle
diameter
1/100 mm
1.05 48
1.7 62
3.5 89
2.9 80
3.1 85
4.2 98
0.9 45
3.3 87
0.9 45
4.0 95
Nominal
heat
capacity
(kW)
1.05
1.7
3.5
2.9
3.1
4.2
0.9
3.3
0.9
4.0
By-pass Reduce Capacity
mm d heat g/h G30
1/100 capacity
(W)
30 400
33 500
50 1050
50 1050
50 1050
65 1600
30 400
55 1200
30 400
55 1200
5.5 Adjusting the primary air flow
Town gas – G110 8 mbar
Nozzle Reduced heat capacity
diameter
1/100 mm
132
165
250
230
240
300
126
250
126
300
Capacity
g/h G31
76 75
124 121
254 250
211 207
225 221
305 300
62 61
240 236
62 61
291 286
".
(W)
400
500
900
1.05
900
1100
400
1200
400
1200
27