Operating Manual; Installation Of The Unit - GE ERESCO MF4 Series Operating Manual

2.

Operating Manual

Preliminary remarks: The following Operating Manual does not contain instructions
2.1

Installation of the Unit

The connection diagram in Fig. 1 and the connection plan in Appendix 2 display the
necessary connections.
Radiating unit
Fig. 1 - Connection diagram
Figures 2 and 5 display the front and side view of the digital control unit ERESCO MF4 control.
It is advisable to carry out installation in the following order:
1. If necessary, use a support to position the radiating unit for exposure.
2. Connect the connecting cable to the radiating unit (X1).
3. If necessary, connect the water cooling pump or the water turbine flow rate monitor
4. Using the whole length of the connecting cable, position the control unit as far away from
NOTE:
Copyright by GE Sensing & Inspection Technologies GmbH
12
Operating Manual ERESCO MF4 Type Series
on adherence to obligatory radiation protection.
It is the responsibility of the user to equip operating personnel with
dosimeters and to monitor them, as well as to carry out any struc-
tural radiation protection measures.
With regard to exposure conditions for achieving minimum image
quality, we refer to relevant DIN regulations.
Connecting cable
Control unit
to the control unit (X4).
the radiating unit as possible, facing away from the radiation; connect the connecting
cable to socket X5 and the mains cable to socket X1. The plug connections are non-
interchangeable.
Orange mains cable with "Schuko" plug 230 V AC only !
Grey mains cable without "Schuko" plug 115 V AC only !
The digital control unit ERESCO MF4 control can operate with restrictions
(see section 3.), also as stand-alone equipment (without X-ray unit).
230 V / 115 V
X1
X5
X1
CAUTION !
Bogenstrasse 41 D - 22926 Ahrensburg
Power supply cable
additional ground
min. 10 mm² Cu
08/24/2016
6. Edition, ID No.: 37020GB-F