Dynamic Select Button - Mercedes-Benz SLC 300 2019 Operator's Manual

DYNAMIC SELECT button

124
Problem
The coolant tempera-
ture display shows a
value above 248 ‡
(120 †). The coolant
warning lamp may also
be on and a warning
tone may sound.
Notes on towing vehicles
The vehicle is not suitable for attaching tow
bar systems, such as those used for flat tow-
ing or dinghy towing.
Attaching or using tow bar systems may result
in damage to the vehicle.
When towing a vehicle with tow bar systems,
safe driving characteristics cannot be guaran-
teed for the towing vehicle or the towed vehi-
cle.
The vehicle/vehicle combination may swerve.
Observe the permissible towing methods
( page 264) and the notes on towing with
Y
both axles on the ground (
DYNAMIC SELECT button
Use the DYNAMIC SELECT button to change
the drive program. Depending on the drive pro-
gram selected the following vehicle character-
istics will change:
the drive (engine and transmission manage-
R
ment)
the suspension or the adaptive adjustable
R
damping only on vehicles with AMG RIDE
CONTROL sports suspension
the sound of the exhaust system (vehicles
R
with sports exhaust system)
the steering
R
the availability of the ECO start/stop func-
R
tion
Possible causes/consequences and M M Solutions
The coolant level is too low. The coolant is too hot and the engine is
no longer being cooled sufficiently.
Stop as soon as possible and allow the engine and the coolant to
X
cool down.
Check the coolant level (
X
as you do so and add coolant if necessary.
If the coolant level is correct, the engine radiator fan may be faulty.
The coolant is too hot and the engine is no longer being cooled suf-
ficiently.
At coolant temperatures below 248 ‡ (120 †), drive to the near-
X
est qualified specialist workshop.
Avoid heavy loads on the engine as you do so, e.g. driving in
X
mountainous terrain and stop-and-go traffic.
page 264).
Y
page 242). Observe the warning notes
Y
Each time you start the engine with the Smart-
Key or the Start/Stop button, drive program C
is activated. For further information about
starting the engine, see (
Press DYNAMIC SELECT button : as many
X
times as necessary until the desired drive
program is selected.
The selected drive program appears in the
multifunction display. After a short period of
time, the display goes out and the symbol
for the selected drive program appears.
In addition, the current drive program set-
tings are displayed briefly in the multimedia
system display.
i
In a few countries, the ECO start/stop
function is deactivated at the factory due to
the available fuel grade. In this case, the
ECO start/stop function is not available in
any drive program, regardless of the display
in the multimedia system display.
In city traffic and stop-start traffic, drive pro-
gram C is recommended.
page 119).
Y