Roland DJ-808 Owner's Manual page 28

Using Serato DVS
* If "Vinyl/CDJ Control" is not shown, double-click the [MY PRODUCTS]
tab in the my serato screen, and check whether "DVS EXPANSION" is
activated.
If the following screen appears, click [ACTIVATE].
5
Make sure that "Enable Vinyl/CDJ Control" has a check mark.
If it does not have a check mark, add a check mark.
When the Serato DVS Expansion is activated, the DJ-808's sound card
mode switches to "DVS mode. " While the DJ-808 is in "DVS mode, " the
state is as shown below.
Wait until switching is complete (approximately one minute). When
switching is complete, the state is as shown below.
6
Close Serato DJ.
7
Turn off the power of the DJ-808, wait about one minute, and
then turn the power on again.
28
8
Restart Serato DJ.
Wait until the virtual deck with a VINYL control mode button appears.
* It may take some time until you see the virtual deck with the VINYL
control mode button.