Lowering - Mercedes-Benz AMG GT S 2016 Operator's Manual

Always pay attention to the instructions and
safety notes in the "Changing a wheel" sec-
tion ( page 247).
Y
Only use wheel bolts that have been designed
for the wheel and the vehicle. For safety rea-
sons, Mercedes-Benz recommends that you
only use wheel bolts which have been
approved for Mercedes-Benz vehicles and the
respective wheel.
! AMG ceramic high performance com-
pound brake system:
When detaching or attaching the wheel, the
wheel rim may hit against the ceramic
brake disc and damage it.
For this reason, you should proceed care-
fully. Request the assistance of a second
person or use a second alignment bolt.
! To prevent damage to the paintwork, hold
the wheel securely against the wheel hub
while screwing in the first wheel bolt.
Wheel bolt
:
Clean the wheel and wheel hub contact
X
surfaces.
Changing a wheel
Slide the wheel to be mounted onto the
X
alignment bolt and push it on.
Tighten the wheel bolts until they are fin-
X
ger-tight.
Unscrew the alignment bolt.
X
Tighten the last wheel bolt until it is finger-
X
tight.
Lowering the vehicle
G
WARNING
The wheels could work loose if the wheel nuts
and bolts are not tightened to the specified
tightening torque. There is a risk of accident.
Have the tightening torque immediately
checked at a qualified specialist workshop
after a wheel is changed.
Turn the crank of the jack counter-clock-
X
wise until the vehicle is once again standing
firmly on the ground.
Place the jack to one side.
X
Tighten the wheel bolts evenly in a cross-
X
wise pattern in the sequence indicated (:
251
Z