Amg Speedshift Dct 7-Speed Sports Transmission; E-Select Lever - Mercedes-Benz AMG GT S 2016 Operator's Manual

AMG SPEEDSHIFT DCT 7-speed sports transmission

Turn DYNAMIC SELECT controller : until
X
the desired drive program is selected.
The selected drive program appears in the
multifunction display. After five seconds
the display goes out and the status icon of
the selected drive program appears.
The drive program indicator on DYNAMIC
SELECT controller : lights up in red.
In addition, the current settings are dis-
played in the COMAND display.
Additional settings
Manual mode ( page 106)
Y
:
ECO start/stop function (
;
Position of the exhaust flap (
=
Suspension ( page 124)
Y
?
®
ESP ( page 63)
Y
A
When you press buttons : - A the corre-
sponding setting is selected. The DYNAMIC
SELECT controller setting is overwritten.
These settings will also be maintained for
manual mode and ESP ® if you switch to drive
program RACE, S+, S or C using the
DYNAMIC SELECT controller.
If you switch to drive program I, all stored
characteristics will be accepted. This is also
the case if you have previously pressed one of
buttons : - A. If you then change the drive
program using the DYNAMIC SELECT control-
ler, the standard setting for the drive program
is selected.
AMG SPEEDSHIFT DCT 7-speed sports
transmission
Important safety notes
G
WARNING
If the engine speed is above the idling speed
and you engage transmission position D or R,
the vehicle could pull away suddenly. There is
a risk of an accident.
When engaging transmission position D or R,
always firmly depress the brake pedal and do
not simultaneously accelerate.
G
WARNING
The automatic transmission switches to neu-
tral position N when you switch off the engine.
The vehicle may roll away. There is a risk of an
accident.
After switching off the engine, always switch
to parking position P. Prevent the parked vehi-
cle from rolling away by applying the parking
brake.
E-SELECT selector lever
page 103)
Y
page 103) General notes
Y
! If the engine speed is too high or if the
vehicle is rolling, do not shift the transmis-
sion directly from D to R, from R to D or
directly to P.
Do not open the driver's door while the
vehicle is in motion. At low speeds in trans-
mission position D or R, park position P is
otherwise engaged automatically.
The transmission could be damaged.
! If you wish to select a transmission posi-
tion or to disengage park position P, the
engine must be running.
The E-SELECT lever always returns to its orig-
inal position.
The current transmission position P, R, N or D
appears in the transmission position display
in the multifunction display.
105
Z