Mercedes-Benz AMG GT S 2016 Operator's Manual page 221

Turn fasteners : one Õ turn and remove.
X
Remove cover.
X
All vehicles:
Position number B identifies the charged battery of the other vehicle or an equivalent jump-
starting device.
Slide cover A of positive terminal : in the direction of the arrow.
X
Connect positive terminal : on your vehicle to positive terminal ; of donor battery B
X
using the jumper cable. Always begin with positive terminal : on your own vehicle first.
Start the engine of the donor vehicle and run it at idling speed.
X
Connect negative terminal = of donor battery B to ground point ? of your vehicle using
X
the jumper cable, connecting the jumper cable to donor battery B first.
Start the engine.
X
Before disconnecting the jumper cables, let the engine run for several minutes.
X
First, remove the jumper cables from ground point ? and negative terminal =, then from
X
positive clamp : and positive terminal ;. Begin each time at the contacts on your own
vehicle first.
Close cover A of positive clamp : after removing the jumper cables.
X
Vehicles with carbon engine cover:
Replace the jump-starting connection point cover. Make sure all mountings for the fasteners
X
are positioned precisely under the corresponding recesses in the cover.
Press fasteners into the mountings until they engage.
X
All vehicles:
Have the battery checked at a qualified specialist workshop.
X
Jump-starting is not considered to be a normal operating condition.
Jump-starting
219
Z