Important Safety Notes - Mercedes-Benz AMG GT S 2016 Operator's Manual

Features
194

Important safety notes

G
WARNING
When you operate or program the garage door
with the integrated garage door opener, per-
sons in the range of movement of the garage
door can become trapped or struck by the
garage door. There is a risk of injury.
When using the integrated garage door
opener, always make sure that nobody is
within the range of movement of the garage
door.
G
WARNING
Combustion engines emit poisonous exhaust
gases such as carbon monoxide. Inhaling
these exhaust gases leads to poisoning. There
is a risk of fatal injury. Therefore never leave
the engine running in enclosed spaces with-
out sufficient ventilation.
Programming
Programming buttons
Pay attention to the "Important safety notes"
( page 194).
Y
Garage door remote control A is not inclu-
ded with the integrated garage door opener.
Select SmartKey position 2 with the Start/
X
Stop button ( page 100).
Y
Select one of buttons ; to ? to use to
X
control the garage door drive.
To start programming mode: press and
X
hold one of buttons ; to ? on the inte-
grated garage door opener.
The garage door opener is now in program-
ming mode. After a short time, indicator
lamp : lights up yellow.
Indicator lamp : lights up yellow as soon
as button ;, = or ? is programmed for
the first time. If the selected button has
already been programmed, indicator
lamp : will only light up yellow after ten
seconds have elapsed.
Release button ;, = or ?. Indicator
X
lamp : flashes yellow.
To program the remote control: point
X
garage door remote control A towards
buttons ; to ? on the rear-view mirror at
a distance of 2 to 8 inches (5 to 20 cm).
Press and hold button B on remote control
X
A until indicator lamp : lights up green.
When indicator lamp : lights up green:
programming is finished.
When indicator lamp : flashes green: pro-
gramming was successful. The next step is
to synchronize the rolling code
( page 194).
Y
Release button B on remote control A for
X
the garage door drive system.
If indicator lamp : lights up red: repeat the
programming procedure for the corre-
sponding button on the rear-view mirror.
When doing so, vary the distance between
remote control A and the rear-view mirror.
The required distance between remote
control A and the integrated garage door
opener depends on the garage door drive
system. Several attempts might be neces-
sary. You should test every position for at
least 25 seconds before trying another
position.
Synchronizing the rolling code
Pay attention to the "Important safety notes"
( page 194).
Y
If the garage door system uses a rolling code,
you will also have to synchronize the garage