Remote Coding / Programming Routine; Programming 2 Way 5 Button Remotes; Remote Start Error Diagnostic - Firstech 2W902R-SP User Manual

IMPORTANT: Every Firstech remote must be coded to the system prior to performing any operations. All
remotes must be coded at the same time.

Programming 2 Way 5 Button Remotes:

STEP 1: Activate Valet/Programming mode by manually turning the ignition key on and off (between the
Acc & On positions) five times within 7 seconds. The vehicle's parking lights will flash once with the
successful completion of this step.
STEP 2: Within 2 seconds after cycling the ignition for the 5
remotes or the (lock) button on 1 way remotes for a half second. The parking lights will flash once to
confirm the transmitter has been coded.
If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following
those three flashes the parking lights will flash again corresponding to the error table.
Number of
Parking Light
Flashes
1
2
3
5
6
7
8
9
10
We recommend that you do not attempt any repairs on your remote starter. Contact your dealer or call us
directly.

Remote Coding / Programming Routine

Exiting Programming: Programming is a timed sequence. The parking
lights will flash twice signaling the end of programming mode.
Programming Multiple Remotes: After the confirmation flash given in
step 2, code additional remotes by pressing button
remotes or the (lock) button on 1 way remotes. The parking lights will
flash once confirming each additional remote. All systems can
recognize up to three remotes.

Remote Start Error Diagnostic

Remote Start Error
Motor running
Key in ignition on position
Door open (manual transmission only)
Foot brake on
Hood open
Reservation off (manual transmission only)
Tach or voltage sensing failure
DAS sensor movement
System is in Valet Mode
th
time, tap the Lock button
16
on 2 way
on 2 way