Remote Mute; Shock Sensor On/Off; Automatic Button Lock - Firstech 2W902R-SP User Manual

simultaneously for a half second.
IMPORTANT: Even when the siren is muted, it will still go off in the event the alarm is triggered.

Remote Mute

To silent your remote you must turn on Remote Mute on;
STEP 1: Enter remote programming mode by holding the Trunk and Key/Start buttons
simultaneously for 2.5 seconds. The remote will beep 3 times and the LED
will flash purple indicating that you have successfully entered programming mode.
STEP 2 : Tap the Unlock button. The LED will flash blue indicating that silent mode is on. Tap the
Unlock button again to turn Remote Mute off. Two chirps and red LED flashes indicates Remote Mute is
off.
STEP 3: Exit remote programming by holding down the Trunk and Key/Start buttons
simultaneously for 2.5 seconds. The remote will beep indicating that you have successfully exited
programming. Your remote's LED will still illuminate.

Shock Sensor On/Off

Hold the Lock and Unlock buttons simultaneously for 2.5 seconds to turn the
shock sensor on and off. The remote will beep twice and LED flash twice to confirm the shock
sensor is off. The remote will beep once and LED flash once to confirm the shock sensor is on.
IMPORTANT: Turning off the shock sensor also turns off any optional sensors.
Adjusting the shock sensor sensitivity is done at the actual sensor, which is generally mounted
somewhere under the vehicle's dashboard. The higher the number on the dial means greater sensitivity
to impact. The recommended dial setting for most vehicles is somewhere between 2 & 4. If you are
testing your sensor, please note that the shock sensor does not recognize impact for 30 seconds after
the system has been armed.

Automatic Button Lock

Your remote comes with an automatic button lock feature. This feature automatically locks all four
buttons on your remote after one minute. To unlock just tap any button then tap or hold the button(s) for
the command you would like to send. This feature must be turned on in the Remote Option Menu.
STEP 1: Enter remote programming mode by holding the Trunk and Key/Start buttons
simultaneously for 2.5 seconds. The remote will beep 3 times and the LEDs will flash purple on your
remote indicating that you have successfully entered programming mode.
STEP 2 : Tap the Start button. One chirp and LED flash indicates that Automatic Button Lock is on.
Tap the Start button again to turn Auto Button Lock off. Two chirps and LED flashes indicates the
feature is off.
STEP 3: Exit remote programming by holding down the Trunk and Key/Start buttons
simultaneously for 2.5 seconds. The remote will beep indicating that you have successfully exited
programming.
11