Related Manuals for Firstech 2W902R-SP
Summary of Contents for Firstech 2W902R-SP
- Page 1 Applicable to the following remote(s) 2W902R-SP 2 Way 5 Button LED Remote Remote FCC ID Number (US Only) IC ID Number (International Only) 2W902R-SP VA5REC500-2WSP 7087A-2WREC500SP...
- Page 2 By Firstech, LLC By Firstech, LLC By Firstech, LLC...
-
Page 3: Quick Reference
ALARM IT, START IT, or MAX IT system. This manual also supports the 1WG7R-SP that is included in your new RF Kit. Please note that The 2W902R-SP comes equipped with automatic button lock. This requires you to tap any button to wake your remote up then tap the button for the there are certain features listed in this manual that may not be available for your system. - Page 4 This button activates and deactivates multiple features. See the Function Button Menu table below for complete details. the battery. Battery size: Two (2) CR2016) Replacements can be purchased from your local Firstech dealer or an electronics store. By Firstech, LLC...
- Page 5 Display second Half second Full Paging Important: The 2W902R-SP is defaulted in HALF for START IT systems. It must be temperature settings and self start settings. changed to FULL for alarm systems. 2.5 seconds Option programming menu 2. For use during installation.
- Page 6 8 Chirps Your prewarn shock sensor zone has been violated. Chirps for 30 seconds or until Full Shock Sensor Purple and Red Your full trigger shock sensor zone has been violated. button tapped on remote. By Firstech, LLC By Firstech, LLC...
- Page 7 If you would like additional information on the functionality of your 1way companion remote, please visit the support page at www.compustar.com Half second Valet mode (see Valet Mode section for details) to download the full user manual. 2.5 seconds Turns the shock sensor on/off. (Alarm or alarm / Starter systems only) By Firstech, LLC By Firstech, LLC...
-
Page 8: General System Functions
Upon receiving confirmation that your vehicle is running, the remote LED will flash and remote beep to show the run time. The remote start run time can be programmed for 3, 15, 25, or 45 minutes - ask your local Firstech dealer to adjust Option 2-7 if you would like a run time other than 15 minutes IMPORTANT: If the alarm has been triggered (Siren is sounding, parking lights flashing, and horn honking), you must wait until the remote pager has (default). - Page 9 STEP3 : Exit the vehicle and close the door. The vehicle’s engine should shut off instantly or within 10 seconds upon closing the last door. If the vehicle’s engine does not shut off, your door trigger may be functioning improperly. Do not use the remote start feature and take your vehicle to a local authorized Firstech dealer for service.
- Page 10 To silent your remote you must turn on Remote Mute on; roof, or even turn on a rear defroster. These outputs can be configured for pulsed, timed or latched settings. Your authorized Firstech dealer can set these STEP 1: Enter remote programming mode by holding the Trunk and Key/Start buttons simultaneously for 2.5 seconds.
-
Page 11: Advanced System Functions
Repeat to turn turbo timer off. The remote will beep twice and LED flash twice to confirm turbo mode is off. IMPORTANT: To utilize this feature, the emergency / parking brake wire must be connected to the Firstech system. Consult your local authorized dealer for installation. - Page 12 To disarm hold your finger over the Red Circle for 2.5 seconds. Once the LEDs start their circular pattern, enter your 4 digit code. (Refer to Step 4 above.) Two seconds after entering the 4th digit, your system will disarm. By Firstech, LLC By Firstech, LLC...
- Page 13 STEP 1: Disarm/unlock the alarm (remote must be programmed first) and choose a 4 digit code. You can not have zeros. To change knock sensitivity, disarm the system and adjust the switch on the rear of the RPS. The larger the circle, the more sensitive the knock sensor is. By Firstech, LLC By Firstech, LLC...
- Page 14 STEP 6: Turn the ignition off - the Secure Valet Switch is now programmed. Follow steps 3 - 5 to enter your Secure Valet code. If you purchased an Alarm or Alarm and Remote Start system you have the ability to add optional sensors from Firstech, LLC. You have the ability to protect your investment by adding a battery back up system to protect main power to your alarm or a tilt sensor to protect expensive rims and tires.
-
Page 15: Remote Start Error Diagnostic
If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following those three flashes the parking lights will flash IMPORTANT: Every Firstech remote must be coded to the system prior to performing any operations. All remotes must be coded at the same time. -
Page 16: Alarm Diagnostic
Limited Lifetime Warranty Firstech, LLC Warrants to the original purchaser that this product shall be free of defects in material and workmanship under normal use and While the alarm is armed, the LED will blink slowly. While the siren is going off, the LED will indicate which specific zone was triggered. - Page 17 Limited Lifetime Warranty Memo Firstech, LLC. is not RESPONSIBLE OR LIABLE FOR ANY DAMAGES WHATSOEVER, INCLUDING BUT NOT LIMITED TO, ANY CONSEQUENTIAL DAMAGES, INCIDENTAL DAMAGES, DAMAGES FOR LOSS OF TIME, LOSS OF EARNINGS, COMMERCIAL LOSS, LOSS OF ECONOMIC OPPORTUNITY AND THE LIKE that may or may not resulted from the operation of Compustar, Compustar Pro, Arctic Start, Vizion, or NuStart.
- Page 18 By Firstech LLC Version 1.2(C07) 8102REUSL001100 / FT-2W902-ES V1 Toll Free : 888-820-3690 21903 68th Ave S Kent, WA 98032...
- Page 30 Pita y vibra durante 30 segundos o hasta La zona de protección del activador del sensor Full Shock Sensor púrpura y rojo que el botón del control remoto sea apretado. de impacto ha sido invadida. By Firstech, LLC By Firstech, LLC...