Dispenser Display Assembly - GE PFSS9PKY Technical Service Manual

Dispenser Display Assembly

Note: This section will address how to remove the
LCD dispenser display. The procedure to remove the
LED dispenser display is similar.
The dispenser display assembly incorporates the
interface used for temperature control and features.
The assembly also houses the dispenser LED lights.
The display has 5 tabs that hold it to the dispenser
recess.
Tab Locations
To remove the dispenser display:
1. Remove the Phillips-head screw from the
housing.
2. Use a small screwdriver and pry out on the slot
shown in the photo below.
3. Grasp the bottom of the display, pull it out, and
remove it from the recess.
4. Disconnect the wire harness.
Caution: To prevent breaking tabs when installing
the display, fi rst insert the top and right side tabs
into the recess then snap the display in place.
– 44 –
Disconnect
(Continued next page)