Troubleshooting; Servicing The Actuator Or Piping System; Repair Information - Johnson Controls VG1000 Series Installation Instructions Manual

Wiring
Be sure to wire the input lines to the electric actuator correctly for the valve to move in the proper direction.
IMPORTANT: Use copper conductors only. Make all wiring connections in accordance with local, national, and
regional regulations. Do not exceed the actuator's electrical ratings.
Risk of Electric Shock.
Disconnect the power supply before making electrical connections. Contact with components carrying hazardous
voltage can cause electric shock and may result in severe personal injury or death.
Risque de décharge électrique.
Débrancher l'alimentation avant de réaliser tout branchement électrique. Tout contact avec des composants
conducteurs de tensions dangereuses risque d'entraîner une décharge électrique et de provoquer des blessures
graves, voire mortelles.
This product can expose you to chemicals including lead, which is known
to the State of California to cause cancer, birth defects, or other
reproductive harm. For more information, go to www.P65Warnings.ca.gov.
WARNING: BRASS MAY CONTAIN LEAD
To fulfill our obligations towards Article 33, in accordance to the European REACH Regulation No 1907/2006 EC, we hereby inform you that this article contains
the following Substances of Very High Concern mentioned on the Candidate list:
• Lead

Troubleshooting

Servicing the Actuator or Piping System

When servicing the electric actuator or the piping system:
• disconnect the power supply to the actuator
• relieve the pressure in the piping system
IMPORTANT: Do not attempt to manually rotate the drive shaft while the actuator is installed without first
releasing the actuator gears. Manually rotating the drive shaft without releasing the actuator gears may result in
permanent damage to the actuator.

Repair Information

If the VG1000 Series Forged Brass Ball Valve fails to operate within its specifications, replace the unit. For a
replacement valve, contact the nearest Johnson Controls® representative.
This product is made of copper alloy, which contains lead.
The product is therefore not to be used on drinking water.
VG1000 Series Forged Brass Ball Valves Installation Instructions
11