Section 8-Options - Invacare Action 3 NG Service Manual

Installing/Adjusting Hub Brake
NOTE: For this procedure, refer to FIGURE 7.5.
1. Install the hub brake lever with the cable on the backrest canes.
2. Secure the cable to the lever of the brake shoes support by tightening the cable bolt
3. Adjust the cable tension to desire brake effort by screw/unscrew the tensional bolt
situated on the brake shoes support.
4. Repeat STEPS 1 to 3 for the other side
NOTE: the cable adjustment MUST have the same brake effect on both sides.
Cable
Backrest cane
Brake Lever
Brake Shoes Support
FIGURE 7.5
Installing/Adjusting Hub Brake
SECTION 8—OPTIONS
Lever
4 4
Tensional Bolt
Cable Bolt