Invacare Action 3 NG Service Manual page 28

Anti-Tippers
Bracket
Axle Brackets
Locknut
Dust Cap
NOTE: To obtain the desired front seat to floor height (for details, see Seat-to Floor
Height paragraph), it will be necessary to perform one or both of the following:
• Changing the mounting position on the fork. Refer to
Removing/Installing/Repositioning the Caster Assemblies paragraph.
• Changing the fork size or adding/removing height adjustment spacers. Refer to
Adjusting Forks paragraph.
• Changing the rear height positioning and /or the seat angle. Refer to the table
below.
SECTION 5—REAR WHEELS/FRONT CASTERS
Washers
FIGURE 5.1 Removing/Installing Rear Wheels
2 8
Transit Brake
Brake Hardware
Axle Brackets
Hardware
Fixed Axle
1 = 46cm
2 = 48.5cm
3 = 51cm
1
2
3
POSITION 1
POSITION 2