Removing/Installing Swing Away Armrest (N° 2 & N°3) - Invacare Action 3 NG Service Manual

Removing/Installing Swing Away Armrests (n° 2 & n° 3)
Removing/Installing Swing Away Armrest (n° 2 & n° 3)
NOTE: For this procedure, refer to FIGURE 3.2.
Removing Swing Away Armrest
Unlock existing armrest assembly by operate the push bracket
1.
2. Swing back on the existing armrest to remove from the front arm socket.
3. Pull up on the existing armrest to remove from the rear pivot socket.
4. Repeat STEPS 1
Installing Swing Away Armrest
1. If necessary, remove existing armrest assembly as describe above
2. Install new/existing armrest assembly, first into the rear pivot socket and
into the front arm socket.
3. Lock new/existing armrest assembly by operate the push bracket
Make sure that the dog point is properly engaged in its housing.
4. Repeat STEPS 1
Push Bracket
Dog point
3 for opposite side of wheelchair, if necessary.
-
3 for opposite side, if necessary.
-
FIGURE 3.2
Removing/Installing Swing Away Armrest
1 2
SECTION 3—ARMRESTS
.
.
.
Rear pivot
socket