Table of Contents
Advertisement
Wiring Information
Signal cables
The PVS 305SA is capable of receiving signals from PVT wallplates located up to
100 feet (30 meters) away. The optimum distance is between 50 and 75 feet (15 and
22 meters). Minimum distance is 15 feet (4.6 meters).
The RGB cables supplied with the PoleVault
system are terminated to the TIA/EIA T568A
standard.
If other cables are used the RJ-45 termination
must comply with T568A or T568B wiring
standards, and the same standard MUST be
used at both ends of the cables.
Aux audio input cables
Wire the connector for the Aux audio input as balanced or unbalanced audio as
shown below.
Tip
Ring
Sleeves
Tip
Ring
Balanced audio
Line out audio cables
Wire the connector for the Line Out output as balanced or unbalanced audio as
shown below.
Balanced audio
Tip
Ring
Sleeves
Tip
Ring
Switcher control cables
The connector for switcher control should be wired as shown below.
CONTROL
Tx Rx IR
12 V
+
PVS 305SA Switcher's
rear panel
Control port
A B C
D E
+12 VDC input
NOTE
Ground ( )
B Receive (Rx)
A
Transmit (Tx)
50 feet (38 m) maximum
NOTE
A ground wire must be
connected between the MLC
and the switcher.
Do not tin the wires!
Tip
Sleeve
Tip
Sleeve
Unbalanced audio
Tip
NO Ground here
Sleeve
Tip
NO Ground here
If a cable that has a drain wire is
used, tie the drain wire to ground
at both ends.
Transmit (Tx)
B
A
Receive (Rx)
A B
MLC 104 IP Plus
MLS and power ports
MLS PWR
RS-232 12V
PVS 305SA Switcher • Appendix B
Pins:
12345678
T568A
Pin
Wire color
1
White-green
2
Green
3
White-orange
4
Blue
5
White-blue
6
Orange
7
White-brown
Insert Twisted
8
Brown
Pair Wires
NOTE
If you are using Enhanced
RJ-45
Skew-Free™ A/V cable, use the
Connector
TIA/EIA T568A standard only.
Unbalanced audio
CAUTION
For unbalanced audio, connect
the sleeve(s) to the ground contact.
DO NOT
connect the sleeve(s) to
the negative (-) contacts.
T568B
Wire color
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
B-3
Advertisement
Table of Contents
