Table of Contents
Advertisement
A
2.
Turn the worm nut (B, Figure 18) to tilt the head left or
right as required. Use the scale on the ram adapter to
set the desired angle.
Note: The scales on the ram adapter and for head rota-
tion are guides only. Close tolerance work will require
the use of a dial indicator to make sure the head is 90°
to the table in the X and Y axis. Please note the table
is fitted to be slightly higher in front, usually about
0.0005".
!
Be sure to apply torque in two steps using a cross-
ing pattern. Failure to do so could distort the face
of the ram adapter.
3.
Tighten the four hex nuts. Tighten in two steps using
a calibrated torque wrench. Use a crossing pattern to
tighten the nuts. Tighten initially to 25 foot-pounds.
4.
Before applying final torque, check to make sure the
mill head is perpendicular to the worktable.
5.
Set up a dial indicator in a collet and secure using the
draw bar (refer to Figure 20).
6.
Put the spindle drive in neutral.
7.
Set the dial indicator plunger on the worktable. Zero
the indicator.
8.
Rotate the spindle 180 degrees (when rotating, raise
the dial indicator plunger by hand to prevent it from
dropping into the table T-slots).
9.
Read the dial indicator. The indicator should read
zero. If not, loosen the four hex nuts and reposition the
mill head.
18
10. Recheck perpendicularity using the dial indicator.
B
Be sure to apply torque in two steps using a cross-
ing pattern. Failure to do so could distort the face
A
of the ram adapter.
11. Tighten the four hex nuts. Tighten in two steps using
Fig. 18
10.2 MILL HEAD – FORE/AFT ADJUSTMENT
1.
2. Returning to upright position:
Repeat the procedure above until the dial indicator
reads zero in both positions.
!
a calibrated torque wrench. Use a crossing pattern
to tighten the nuts. Tighten initially to 25 foot-pounds,
then tighten to a final torque of 50 foot-pounds.
Setting the angle:
a. Loosen the three ram adapter clamp bolts on the
ram (A, Figure 19). There is no need to loosen the
bolts more than 1/2 turn to allow tilting.
b. Support the mill head with your free hand. Press
upward on the spindle when changing the angle.
c. Turn the ram adapter worm nut (B, Figure 19) to tilt
the head forward and backward. Use the scale on the
ram adapter to locate the desired angle.
a. When returning the mill head to its full upright posi
tion, be sure to support the head by upward pressure
on the spindle as you turn the worm nut.
b. Check to make sure the mill head is perpendicular
to the worktable.
B
A
Fig. 19
MILL
Advertisement
Table of Contents
