Xilinx MicroBlaze Spartan-3E 1600E Edition Getting Started page 20

Executing the Reference System
4.
5.
Note:
the board is connected to a network with a DHCP server running. If the board is not connected, the
DCHP request will time out; however this is not an error. The message to the HyperTerminal is shown
below:
16
To start the kernel image running, which will boot-up µClinux on the HyperTerminal,
the following command is used:
con 0x22000000
After the µClinux kernel boots up, the output on the HyperTerminal will be as
a.
shown in Figure 2-3.
Login into µClinux with a username of root and a passwd of root.
Upon boot-up, the µClinux kernel is set up to request an IP address from a DHCP server, if
# Jan 1 00:01:03 dhcpcd[33]: timed out waiting for a valid DHCP
server response
Figure 2-3: µClinux Boot-Up Screen
Getting Started with the MicroBlaze Development Kit - Spartan3E 1600E Edition
www.xilinx.com
R
UG258_02-03_062606
UG258 (v1.0) June 29, 2006