Frymaster LOV BIGL30 Series Installation, Operation And Maintenance Manual page 27

2. Inspect the filter pan connection fitting to ensure that
both O-rings are in good condition (see Figure 2).
3. Then in reverse order, place the metal filter screen in
the center of the bottom of the pan, then lay a sheet of
filter paper on top of the screen, overlapping on all
sides (see Figure1). If using a filter pad, ensure the
rough side of the pad is up and lay the pad over the
screen, making sure that the pad is in between the
embossed ridges of the filter pan.
4. Position the hold-down ring over the filter paper and
lower the ring into the pan, allowing the paper to rest
on the sides of the filter pan (see Figure 3).
5. When the hold-down ring is in position, if using filter
paper, sprinkle one packet of filter powder or the
manufacturers recommended amount evenly over the
paper. (See Figure 4)
DO NOT use filter powder with the pad!
6. Replace the crumb tray in the filter pan, then push the
filter pan back into the fryer, positioning it under the
drain.
4.2 Filtration
An M3000 controller prompts the user when to filter on the Manual LOV™ fryer if option is
selected in setup. After a preset number of cook cycles the controller displays filter now?
alternating with YES NO. Follow the instructions on page 2-15 in the controller manual. If NO is
selected or a cook cycle is started, the controller will prompt again soon to filter the oil.
On demand filtration is used to manually start a filter. See page 2-14 in the controller manual for the
filter menu.
The fryer MUST be at setpoint temperature for any filtration operation to start.
Note: Do NOT filter multiple vats simultaneously.
4.2.1 Operation of the Filter
Draining and filtering of cooking oil must be accomplished with care to avoid the
possibility of a serious burn caused by careless handling. The oil to be filtered is at
or near 350°F (177°C). Ensure drain handles are in their proper position before
operating any switches or valves.
draining and filtering cooking oil.
Inspect the filter
connection fitting
O-rings.
DANGER
Wear all appropriate safety equipment when
4-2
Figure 2
Figure 3
Figure 4