Storing Accessories - Makita 2712 Instruction Manual

Fig.2
8. Turn the table saw back and then attach the
carrying handles.
Fig.3
9. Install the switch to the leg and secure it with the
tapping screws.
Fig.4
10. Install the saw blade and blade guard. When
installing them, refer to the Section "Removing or
installing saw blade" and "Installing blade guard".
11. Install the guide rail (short) to the front side of the
table saw and the guide rail (long) to the left side
of the base.
1. Guide rail
2. Square neck bolt
014572
12. Install the sub table to the base. Select the proper
length stays depending on the position.
1
2
2
1
1
2
3
1. Sub table
2. Stay (long)
3. Stay (short)
014573
2
3
1. Sub table
2. Stay (short)
3. Stay (long)
014574
13. Install the hook to the leg.
Fig.5
14. Locate the table saw in a well lit and level area
where you can maintain good footing and balance.
It should be installed in an area that leaves
enough room to easily handle the size of your
workpieces.
If there is any tendency for the table saw to tip
over, slide or move during operation, the table
saw should be secured to the floor.

Storing accessories

Fig.6
Push stick and wrenches can be stored on the right side
of the tool.
8
1