Troubleshooting; Programming - Jackson Dynatemp Series Installation, Operation And Service Manual

TROUBLESHOOTING

PROGRAMMING

07610-004-29-29-D
To access programming, the machine should be on and not in cycle
The programming buttons (Up-arrow, Down-arrow, and Select) are hidden on the
display and are shown below as red outlines There is a full-size display template at
the end of the manual to help locate the programming buttons
Factory Setup (Model Selection)
1. Press and hold the I and III Buttons until "Program" starts flashing (2 - 3
seconds).
2. Press the Select Button.
3. Use the Up-arrow or Down-arrow Button to change the program number to "4."
4. Press the Select Button.
5. "Program" will flash.
6. Press the Delime Button to exit.
PROGRAMMING
P R O G R A M
P R O G R A M
4
1 5 0 F
R E A D Y
C Y C L E 1
20