Avaya Remote Gateway 911 Series Quick Start Manual page 8

Avaya Remote GatewayInstallation
8
To connect the Remote Gateway 911x series unit to the power source as follows:
1
2
3
As soon as you connect the Remote Gateway 911x unit to the power source, the
unit begins to power up and the power LED comes on. The power-up cycle takes
about 30 seconds to complete. When the Remote Gateway 911x unit completes a
successful self-test, the power LED flashes three times and the telephone display
shows one of the following two messages:
•
•
The ETHERNET TX and RX LEDs flash only during transmit and receive
activity.
N0027496
Connect the plug on the power transformer to the POWER connector on the
Remote Gateway 911x series unit.
Attach the power cord to the power transformer.
Plug the power supply into an uninterruptible power source (UPS) or wall
outlet.
a time and date, if connected to a PBX
HOSTLESS MODE, if the 911x unit is not configured