Maximum Vol Function; Maximum Vol Level; Button Lock; Power Button Lock - Panasonic TH-98SQ1W Operating Instructions Manual

Maximum VOL function

Enables/Disables [Maximum VOL function].
[Off]:
The sound volume level can be set up to 100
(maximum).
[On]:
The volume cannot be set to the level higher than
the level set for [Maximum VOL level].

Maximum VOL level

Sets the sound volume when [Maximum VOL function]
is enabled.
Note
● Outputs with the set volume when [Maximum VOL
level] in [On] state is selected on the menu.
● When the [Maximum VOL function] is switched from
[Off] to [On], if the [Maximum VOL level] is set lower
than the [Initial VOL level], the [Initial VOL level]
automatically becomes the same as the [Maximum
VOL level].

Button lock

Limits operation of the buttons on the unit.
[Off]:
All the buttons on main unit can be used.
[On]:
All button operations except for the <Main Power
On / Off button> are disabled.
[MENU & ENTER]:
Locks <MENU (Unit)> and <ENTER (Unit)>
buttons.
■
To set [Button lock]
Set with the buttons on the unit.
[Off]:
Press <+ (Unit)> for 4 times.
Press <INPUT (Unit)> for 4 times.
Press <- (Unit)> for 4 times.
Press <ENTER (Unit)>.
[On]:
Press <- (Unit)> for 4 times.
Press <ENTER (Unit)> for 4 times.
Press <+ (Unit)> for 4 times.
Press <ENTER (Unit)>.
[MENU & ENTER]:
Press <ENTER (Unit)> for 4 times.
Press <+ (Unit)> for 4 times.
Press <INPUT (Unit)> for 4 times.
Press <ENTER (Unit)>.
82
English
Note
● About how to reset the settings to defaults, refer to
"Initialization". (see page 131)

POWER button lock

Sets the lock setting for the display <Main Power On /
Off button>.
[On]:
<Main Power On / Off button> operation is
disabled.
[Off]:
<Main Power On / Off button> operation is
enabled.

Controller user level

Limits operation of the buttons on the remote control.
[Off]:
You can use all of the buttons on the remote
control.
[User1]:
You can only use <Standby (ON/OFF) button>,
<INPUT>, <RECALL>, <MUTE>, <VOL +> and
<VOL -> buttons on the remote control.
[User2]:
You can only use <Standby (ON/OFF) button> on
the remote control.
[User3]:
Locks all the buttons on the remote control.
Note
● About how to reset the settings to defaults, refer to
"Initialization". (see page 131)

DVI-D/SLOT select

Selects a terminal to use.
[DVI-D]:
Uses DVI-D IN terminal.
[SLOT]:
Uses SLOT.

USB select

Selects a USB port to use for the USB function.
[MP1]:
Uses MP1 as a function operation terminal.
[MP2]:
Uses MP2 as a function operation terminal.
Note
●
Regardless of the setting, both terminals can be used
for power supply. (see page 28)