Selecting The Input Signal; Recall - Panasonic TH-98SQ1W Operating Instructions Manual

Selecting the input signal

Select the signals input to the unit.
Press <INPUT> or <INPUT (Unit)>.
Unit
INPUT MENU
Switches input every time the buttons are pressed.
[HDMI1] → [HDMI2] → [DisplayPort] →
[DIGITAL LINK] → [DVI-D] (or [SLOT]) → [PC] →
[USB] → [MEMORY VIEWER]
[HDMI1]: HDMI 1 terminal, HDMI input
[HDMI2]: HDMI 2 terminal, HDMI input
[DisplayPort]: DisplayPort IN terminal, DisplayPort
input
[DIGITAL LINK]: DIGITAL LINK terminal, DIGITAL LINK
input
[DVI-D]*: DVI-D IN terminal, DVI-D input
[SLOT]*: Input signal of the function board
[PC]: PC IN terminal, PC input
[USB]: USB terminal, USB input
[MEMORY VIEWER]: USB terminal, "Memory viewer"
input
*: For [DVI-D] and [SLOT] input, either one selected for
the [DVI-D/SLOT select] setting is displayed. (see
page 82)
Note
●
Displays the signal name as set in [Input label]. (see
page 63)
●
Input will not be switched unless [Input lock] is set to
[Off]. (see page 69)
●
Image retention (image lag) may occur on the LCD
liquid crystal panel when a still picture is kept on
the panel for an extended period. To prevent such a
problem, using the screensaver and the [Wobbling]
function is recommended. (see page 62, 63)
-
+
ENTER
PC
Full

RECALL

It is possible to check the setting status of input label,
picture mode, etc.
Press <RECALL>.
Current setting status will be displayed.
10:00
Off timer
1 Input label
2 Aspect mode (see page 37)
3 Backup input change (see page 61, 62)
4 Audio input (see page 66)
5 Profile name (see page 49)
6 [Schedule play mode] (see page 111)
7 Off timer remaining time (see page 36)
8 Clock / Mute (see page 36, 71)
● When there is no video signal to the selected input,
[No signal] is displayed for about 30 seconds at the
end.
●
When a USB memory is not connected to the USB
terminal at the time of switching to the USB input, [No
external media] is displayed for about 30 seconds.
Even when a USB memory is connected, if it does not
contain any playable file, [No play file] is displayed at
all times.
●
When [No signal image settings] - [Display setting] is
set to [On] (see page 68), the message [No signal] /
[No external media] / [No play file] are not displayed.
Instead, the image set in [No signal image settings]
will be displayed.
●
To display the clock, set [Date and time] and then set
[Clock display] to [On]. (see page 70)
HDMI1
Full
Backup mode OK
AUDIO IN1
Memory name: MEMORY2
Schedule play mode
90 min
English
1
2
3
4
5
6
7
8
35